Page 1 of 1

Error autoscript teamspeak 3

PostPosted: Mon Dec 05, 2016 6:49 am
by illusionist
hello all,

I installed my teamspeak 3 server according to the Eltechs manual. Everything is working fine and me and my friends can connect to the server :)

The only problem is that i can not make an autoscript it get an error in the end :(
pi@raspberrypi:~ $ wget ... teamspeak3
converted '' (ANSI_X3.4-1968) -> '' (UTF-8)
--2016-12-05 13:02:53-- ... teamspeak3
Resolving (
Connecting to (||:80... connected.
HTTP request sent, awaiting response... 200 OK
Length: 924 [application/octet-stream]
Saving to: 'teamspeak3'

teamspeak3 100%[=====================>] 924 --.-KB/s in 0s

2016-12-05 13:02:54 (28.6 MB/s) - 'teamspeak3' saved [924/924]

pi@raspberrypi:~ $ sudo mv teamspeak3 /etc/init.d
pi@raspberrypi:~ $ sudo chmod 755 /etc/init.d/teamspeak3
pi@raspberrypi:~ $ sudo update-rc.d teamspeak3 defaults
perl: warning: Setting locale failed.
perl: warning: Please check that your locale settings:
LANGUAGE = (unset),
LC_ALL = (unset),
LANG = "en_GB.UTF-8"
are supported and installed on your system.
perl: warning: Falling back to the standard locale ("C").
pi@raspberrypi:~ $

I hope there will be some feedback to fix this problem!

Thanks in advance

Re: Error autoscript teamspeak 3

PostPosted: Wed Dec 07, 2016 12:50 pm
by goha
Hello illusionist!
This is a warning message, not error message. And maybe not connected to Teamspeak at all. It just appears whenever you call perl.
Please reboot your device and check if Teamspeak actually autostarts or not.